HSN code 7205 — GRANULES AND POWDERS, OF PIG IRON, SPIEGELEISEN, IRON OR STE
HSN · heading18%हिंदी में देखें · தமிழில் பார்க்க
GRANULES AND POWDERS, OF PIG IRON, SPIEGELEISEN, IRON OR STEEL
This code covers finely divided forms of pig iron, spiegeleisen, and various grades of iron or steel that have been reduced to granules or powder form. These materials are typically used as raw inputs in steelmaking, foundry operations, and powder metallurgy.
current gst rate
| igst | cgst | sgst | condition |
|---|---|---|---|
| 18% | 9% | 9% | Sch II S.No 264 |
source: 9/2025-Central Tax (Rate) · effective 2025-09-22 · all codes at 18%
gst calculator — pre-filled with this rate
products commonly classified here
atomised ironiron granulesiron metallurgical powderiron powderpig iron powderpowdered ironreduced iron powderspiegeleisen granulessteel granulessteel powder
more specific codes
sibling codes
- 7201PIG IRON AND SPIEGELEISEN IN PIGS, BLOCKS OR OTHER PRIMARY FORMS
- 7202FERRO-ALLOYS
- 7203FERROUS PRODUCTS OBTAINED BY DIRECT REDUCTION OF IRON ORE AND OTHER SPONGY FERROUS PRODUCTS, IN
- 7204FERROUS WASTE AND SCRAP; REMELTING SCRAP INGOTS OF IRON OR STEEL
- 7206IRON AND NON-ALLOY STEEL IN INGOTS OR OTHER PRIMARY FORMS (EXCLUDING IRON OF HEADING 7203)
- 7207SEMI-FINISHED PRODUCTS OF IRON OR NON-ALLOY STEEL
- 7208FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, HOT-ROLLED, NOT
- 7209FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, COLD- ROLLED (CO
- 7210FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, CLAD, PLATED OR
- 7211FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, NOT CLAD, PLAT
- 7212FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, CLAD, PLATED O
- 7213BARS AND RODS, HOT-ROLLED, IN IRREGULARLY WOUND COILS, OF IRON OR NON-ALLOY STEEL
Not sure this is the right code? Try the guided finder →
compiled from official sources · not tax advice · verify with your tax advisor before filing