HSN code 7211 — FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH
HSN · headingहिंदी में देखें · தமிழில் பார்க்க
FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, NOT CLAD, PLATED OR COATED
Flat steel sheets and coils made from iron or non-alloy steel, narrower than 600 mm, in their plain uncoated form. These are hot-rolled or cold-rolled steel products without any protective surface coating.
products commonly classified here
cold-rolled steel stripsnarrow flat steelnarrow steel coilspickled steel stripsplain steel stripssteel band coilssteel stripssteel tape coils
more specific codes
sibling codes
- 7201PIG IRON AND SPIEGELEISEN IN PIGS, BLOCKS OR OTHER PRIMARY FORMS
- 7202FERRO-ALLOYS
- 7203FERROUS PRODUCTS OBTAINED BY DIRECT REDUCTION OF IRON ORE AND OTHER SPONGY FERROUS PRODUCTS, IN
- 7204FERROUS WASTE AND SCRAP; REMELTING SCRAP INGOTS OF IRON OR STEEL
- 7205GRANULES AND POWDERS, OF PIG IRON, SPIEGELEISEN, IRON OR STEEL
- 7206IRON AND NON-ALLOY STEEL IN INGOTS OR OTHER PRIMARY FORMS (EXCLUDING IRON OF HEADING 7203)
- 7207SEMI-FINISHED PRODUCTS OF IRON OR NON-ALLOY STEEL
- 7208FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, HOT-ROLLED, NOT
- 7209FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, COLD- ROLLED (CO
- 7210FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, CLAD, PLATED OR
- 7212FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, CLAD, PLATED O
- 7213BARS AND RODS, HOT-ROLLED, IN IRREGULARLY WOUND COILS, OF IRON OR NON-ALLOY STEEL
Not sure this is the right code? Try the guided finder →
compiled from official sources · not tax advice · verify with your tax advisor before filing